Specification:
Origin: Mainland China
Type: Voltage Regulator
Condition: New
Application: Computer
Supply Voltage: 3.7 V
Model Number: Inductor Capacitor Meter
Product size: 75 x 70 x 15mm/3.0 x 2.8 x 0.6inch
Caution:
Short the three test terminals and enter the test, the screen prompts for the correction procedure. When prompted to disconnect the calibration time short end off the three tests will continue, when prompted to access 100nF capacitors on pins 1-3 over time, access to power distribution 1uF calibration capacitors after the program will automatically enter the next step. Until the end of the calibration restart to complete the calibration.
Range of use:
1. using ATmega8, ATmega168 or ATmega328 microcontrollers
2. 2x16 character LCD display of results.
3. One-button operation with automatic shutdown.
4. Shutdown current of only 20nA, battery operation supported.
5. Automatic pin layout detection.
6. Supports two types of resistance measurement and symbol display up to four digits and units
7. Software can set the number of measurements before automatic power off
Product features:
1. One button measurement operation with automatic switch-off delay. Shutdown current is only 20nA and battery operation is supported.
2. Automatic detection of PNP and NPN bipolar triodes, N and P-channel MOSFETs, JFET field effect tubes, diodes, diodes, thyristors, resistors, capacitors, inductors. Automatic detection of pin definitions.
3. Measurement of the current amplification factor (B) and the on-state voltage (Uf) of the emitter junction for bipolar transistors. The amplification of Darlington transistors can be identified by high threshold voltages and high currents.
4. It detects the internal protection diodes of bipolar transistors and MOSFETs and displays them on the screen.
5. It measures the threshold voltage and gate capacitance of MOSFETs.
6. It supports two resistance measurements and can measure potentials. If the potentiometer is set to the end, the tester cannot distinguish between the middle and the two ends of the pin.
7. Resistance measurement resolution is 0.1 Ohm, maximum measurement 50M Ohm value.
8. Capacitance measurement range from 25pf to 100mF (100000 UF). Resolution up to 1pF, inductance measurement range 0.01MH-20H, otherwise it will be displayed as resistance, inductance DC resistance will also be displayed as resistance if Ou2100 is high.
9. Can detect the equivalent series resistance of capacitors above 2UF with a resolution of 0.01 ohms. This feature is very important for the detection of capacitor performance.
10. It can display the sign of two diodes in the correct direction and can also display the forward voltage drop.
11. The LED detects diodes with a higher than normal forward voltage drop. The double LED detection is a double diode. Simultaneous detection of the light emitting diodes will flash.
12. Each test takes about two seconds, only measurements of large capacitors and inductors take a long time.
Note:
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.
Package Content:1 x Tester (Batteries Not Included)
3pcs x High Quality Test Clips
